Programming instructions

BreezeCONFIG DS
3-11
Alvarion
! Link Counters
The Tx Success and Tx Fail counters displayed at the end of the
counters list are link-specific; to activate these counters for a specific
link, select the MAC address of the unit at the other end of the link and
click Apply.
When you click the Reset Counters button, these counters are actually
reset (unlike the other counters which are only reset on screen).
" Tx Success - The number of data and management frames
(except to beacons and multicasts) that were transmitted
and acknowledged by the intended recipient.
" Tx Fail - The number of data and management frames
(except to beacons and multicasts) that were transmitted
without being acknowledged by the intended recipient.
" Tx Fail (%) – The percentage of data and management
frames (except to beacons and multicasts) that were
transmitted without being acknowledged by the intended
recipient, calculated as follows:
100*T x Fail / (Tx Success x Tx Fail)
Resetting Counters
You can reset the counters displayed in the Counters tab by clicking the
Reset Counters button. All displayed values are reset to display zero.
Note that this action does not reset the counters stored in the actual
unit, but just resets the values displayed in the screen (an exception to
this are the Link Counters). Therefore, if you exit the Counters tab, after
performing a reset and reopen it at a later time the counter values are
displayed to reflect the values stored in the unit. To reset the counters
in the unit, turn off the unit and then turn it back on.
WLAN Parameters Tab
The WLAN parameters tab allows you to define or edit parameters
related to the Wireless LAN environment in which the selected unit is
operating. The window displayed varies depending on the type of unit
selected.