User guide

8-6
BreezeNET DS.11b User’s Guide
Manual Version 1.0
! Filtering traffic exchanged between two specific stations that are identified
by their static MAC address (see Static MAC Address Filter).
! Enabling the spanning tree mechanism to resolve the closed network loops
errors (see Spanning Tree).
! Storm threshold filtering to limit the number of messages per port and/or
station from being bridged (see Storm Threshold).
The Bridge parameter settings are typical “common” parameters, i.e. the Bridge
parameter settings should be the same for all Base Stations.
Figure 8-36: Bridge Tab in the Edit Mode
To set the Bridge parameters, connect to the Base Station and select the
Bridge
tab to display the bridge parameters as pictured in Figure 8-36 : Bridge Tab in
the Edit Mode.
Protocol Filtering
The filtered protocols are listed in the top section of the Bridge tab. The
factory-set default of the Base Station is
<None> which will allow all protocols to
be transmitted to the wireless medium. This is the recommended setting when
you do not require specific protocols to be filtered.
To filter specific protocols, proceed as follows: