User guide

Appendix C
C-3
Alvarion
! Your LAN administrator station is a wired (Ethernet) station.
Your LAN administrator station is a Wired
Station
Your LAN administrator station is connected to the Base Station via the
Ethernet interface of the Base Station.
! Make sure the LAN administrator station and the Base Station are
connected to the same LAN segment (subnet).
To communicate with the Base Station in “Forced Reload” state, no routers
are allowed between the target Base Station and the LAN administrator
station.
! When using IP addressing, write down the IP address that the Base Station
should use.
Your LAN administrator station is a Wireless
Station
You can use a wireless LAN administrator station to access the Base Station in
force reload mode ONLY IF the station has indirect access to the Base Station,
as described in Figure 3-8 on page 3-14.
Make sure that your LAN administrator station matches the settings of the Base
Station that you will use to establish the connection to in forced reload mode.
! Make sure the LAN administrator station is within range of the Base
Station.
When using IP addressing, write down the (new) IP address that you would like
to assign to the Base Station in forced reload mode.
Step 2 - Set to “Forced Reload”
Mode
1. Remove the cover of the Base Station.
2. Locate the two small holes on the long-edge side of the processor module,
marked “Reset” (A) and “Reload” (B) (see Figure C-44).
Figure C-44: Reset and Reload Buttons