User`s guide

SA-PCR PRO.11 PC Card Installation, Setup, and Management
BreezeNET PRO.11 Series
4-39
User’s Guide
Configuration Notes
1. To configure the SA-PCR, use the brzsetup.exe configuration utility.
2. A sample net.cfg file is provided; you may edit this to configure the parameters
for IRQ and MEM.
3. For DOS versions 3.30 to 6.20, LASTDRIVE=E by default. If the user only has
drive C, letters D and E will be available for Novell network drives. To make
all letters available for the network, add LASTDRIVE=Z to the config.sys file.
4. The units can only work with AP-10 PRO. 11 (which have 802.11 software
version 4.3 or later).
5. To see the version of the SA-PCR, ensure that the card is inserted and run the
Site Survey utility.
6. For configuration of the NDIS2 stack using ODINSUP, refer to the ODINSUP
documentation.
Running the Configuration Utility
1. Change to the NetWare client directory.
2. Type brzsetup and press Enter.
3. Enter the ESS ID as defined in the AP (if using default ESS ID, do not change).
4. Reset/restart the computer.
Note: Default ESSID is ESSID1 in capital letters.