User`s guide

SA-PCR PRO.11 PC Card Installation, Setup, and Management
User’s Guide
4-40
BreezeNET PRO.11 Series
Troubleshooting ODI Installation
The following paragraphs provide information that can help in the event of
problems encountered in the ODI drivers installation.
• It is important to note which net.cfg and brzwlan.ini is used. After installation
of new Novell client, two copies of brzwlan.ini, brzwlan.com and net.cfg files
may exist, one in the Windows directory and another in the directory where the
Novell client is installed.
• If Card Services fails to provide correct memory and IRQ automatically – edit
net.cfg and use IRQ and MEM parameters.
• If the driver did not display a message Testing Device, this indicates that
Card Services failed to recognize the card or to provide the required
information to the driver. Check the Card Services information configuration.
• The driver reports an error in allocating IRQ or memory. The Card Services
failed to provide the required resources to the driver, or there are no resources
available. Reboot without EMM386 or other programs that may take up the
adapter memory region. Change the IRQ or MEM parameters in net.cfg to
force the driver to request specific resources.
• The driver reports errors in net.cfg or brzwlan.ini. The files are corrupt or you
are not in the correct directory.
• The yellow LED blinks and turns off after several seconds. The AP is
configured with incorrect parameters. Check the AP configuration. The built in
antennas are not pulled out or the external antenna is not attached to the PC
card.
• The yellow LED does blink and is not lit. The driver is not receiving
interrupts. Try to change IRQ – wrong firmware version or card initialization
error.