User`s guide

Accessory Installation
User’s Guide
6-4
BreezeNET PRO.11 Series
4. Attach the LNA 10 RF output directly to the RF cable going down to the
receive antenna connector on the BreezeNET PRO.11 unit.
5. Connect the RG-59 coaxial cable which leads down to the Power Inserter to the
“Signal and Power out” connector on the LNA 10.
6. Connect the Power Inserter to the power supply (both are indoor units).
7. For transmission, use a separate antenna connected to the other antenna
connector (transmit antenna) of the BreezeNET unit.
Figure 6-2. LNA 10 Connections Diagram
6.3 RFS 122 Radio Frequency Splitter
The RFS 122 Radio Frequency Splitter is used to split the RF signal generated by a
transmitter into two signals. These signals are then sent to two different and
independent antennas. The RFS 122 enables radio transmission using two
directional antennas connected to the same port of the BreezeNET PRO.11 unit.