User`s guide

Using the Local Terminal for Unit Setup and Management
User’s Guide
3-4
BreezeNET PRO.11 Series
Menu Sub-Menu Sub-Menu Default Values
2.5. Rate 2.5.1 Multi-Rate Support Enabled
2.6. AP Redundancy
Support
Disabled
2.7. Maintenance 2.7.1 Auto Calibration
2.7.2 Wait for Association Address
2.7.3 Japan Call Sign
Enabled
(not available in APs)
3. Site Survey 3.1. System Counters 3.1.1 Display Ethernet and WLAN Counters
3.1.2 Display Rate Counters
3.1.3 Display Rx packets per frequency
3.1.4 Reset All Counters
3.1.5 Power Saving Counters
3.2. Survey Software 3.2.1 Operation mode(RX/TX)
3.2.2 Start Statistics
3.2.3 Stop Statistics
RX only
3.3. Event Log 3.3.1 Display Event Log
3.3.2 Erase Event Log
3.3.3 Event storage policy From level warning
up
3.4. Display
Neighboring APs
4. Access Control 4.1. Change Access
Rights
4.1.0 User
4.1.1 Installer
4.1.2 Technician
Installer
4.2. Change Installer
Password
"User"
4.S Show Current
Access Right
* Option 1.3.5 Transmit Antenna has the default value Use #2 for the SA-40
unit only.
** Option 1.3.7 Load Sharing has the default value Enabled for the AP-10 unit
only.