Upgrade Pack with 360 Continuous Servo Manual

Step 5.
Uninstall the Pan Gear Mount from the old assembly
and install it with the M0.5 150T Main Gear using
4pcs M2x6mm Hex Cap Screws.
Step 6.
Insert the Upgrade Pan Main Gear into the Panning
Mmain Shaft and install the 360 Degree Pan Servo
onto the Outer Frame using 4pcs M2x10mm Screws
with spacers. (Apply little amount of Thread Locker to
the screws when installing metal parts.)
Step7.
Adjust whole 360 Degree Servo Assemnly to fit two
upgrade M0.5 gears. Secure the 360 Degree Servo and
test it with a Servo Tester or Receiver.
Step 8.
Install the Mounting Frame to the panning Main Shaft
Gear Mount with 4pcs M2.5x6mm Hex Cap Screws.
(Apply little amount of Thread Locker to the screws
when installing metal parts.)
Page 13 of 15