Service manual

Always On UPS Systems

M0704_NX_Series_Service_Manual V2.17 2012-06-12 25

14.2. Menu 1 – Select Menu

MENU 1 is reached by pressing any button on the opening screen and is also the default

menu. From this menu the personnel can select STATUS WARNING FAULT (MENU 2 –

Section 10.3), REAL TIME DATA (MENU 3 – Section 10.4), HISTORICAL DATA (MENU 4

– Section 10.5) and PARAMETER SET (MENU 5 – Section 10.6). To select an option

move the cursor (→) by pressing the UP (↑) key, or the DOWN(↓) key. Selections are

confirmed by pressing the ENTER (↵) key. The user will be sent to the menu the cursor is

pointing to. If the item ‘PARAMETER SET’ is selected, the LCD will jump into a screen that

will prompt the user for a password. See the figure below.

The numbers are changed by pressing the UP (↑) or the DOWN(↓) key respectively and is

confirmed by the ENTER(↵) key. When the four-digit password has been entered

successfully you will proceed to the selected area. If the password has been entered

incorrectly three times the display will revert to the default menu (MENU 0).

The password for entering the < PARAMETER SET > menu is 1-2-3-4. To change the

password, please review MENU 12 (Section 10.13).

To return to MENU 0 select the ‘EXIT’ option (blinking instead of pointed by cursor).

SELECT MENU

STATUS WARN I NG FAULT PARAMETER SET

REAL TI ME DATA

HI STORI CAL DATA EXI T

PASSWORD: 1 23 4

Figure 14.2.1

Select Menu Dis

Figure 14.2.1

Password Menu Dis