User manual

Always “On” UPS Systems Inc.

3 Version 2.2

1 REPLACE BATTERY indicator (RED LED)

This LED illuminates when the UPS's batteries are no longer useful

and must be replaced.

Note: When replacing the batteries, disconnect the utility power and

then open the case. Take notice of the polarity before installing the

new batteries to avoid a short.

2 BUCK AVR (VOLTAGE REDUCTION) indicator (YELLOW LED)

This LED illuminates when the UPS is correcting a high utility

voltage condition. The loads receive normal power.

3 BACK-UP indicator (YELLOW LED)

This LED illuminates when the UPS is supplying battery power to the

loads.

4 BOOST AVR (VOLTAGE BOOST) indicator (YELLOW LED)

This LED illuminates when the UPS is correcting a low utility voltage

condition. The loads receive normal power.

5 LINE NORMAL indicator (GREEN LED)

This LED illuminates when the line-input voltage is normal. (RM

version; also flashes to indicate Backup mode)

6 ON/OFF/TEST/SILENCE button (TEST / SILENCE for GES-

102VR). Press and hold the button for more than 3 seconds to turn

the UPS “ON” or “OFF” (not applicable to GES-102VR). Press and

hold the button less than 1 second to activate a self-test, or silence the

back up alarm.

7 UPS OUTPUT SEGMENT 1 ON / OFF SWITCH

This switch allows independent ON / OFF control of UPS output

segment 1 outlets on rear panel.

8 UPS OUTPUT SEGMENT 2 ON / OFF SWITCH

This switch allows independent ON / OFF control of UPS output

segment 2 outlets on rear panel.

9 BYPASS ON/OFF SWITCH

This switch allows independent ON / OFF control of the surge-

protected outlet on rear panel. (This outlet is not supplied backup

power in the event of a power outage)

10 MAIN POWER

This toggle switch is the main power cutoff for the UPS. Use of this

switch will remove power from loads and completely shutdown the

UPS.