User manual

12 Functions and operations in the tension control mode
−102−
12 Functions and operations in the
tension control mode
When winding a roll of film, paper, etc., the diameter of material is different between the start and end of
winding. Therefore, the torque must be changed according to the changing diameter to keep the tension at a
constant level. This type of control is possible in the tension control mode.
12.1 Quick operations
If you are new to the NX series driver, read this chapter and you will be able to perform basic motor
operations.
Note
Before operating the motor, check the condition of the surrounding area to ensure safety.
STEP 1 Check the installation and connection
Check
Motor and driver installation
Programmable
controller
Check
Motor connection
Check
Power supply
connection
Check
CW (CCW) input connection
Check
CN1 connector connection
Check
Encoder connection
P.45
P.31
P.21
P.4 3
P.3 2
P.31