User manual

18 Options (sold separately)
−143−

Accessory set
Use an accessory set if the analog I/O functions are to be used.
Model: AS-SV2
A set of one CN6 connector and two variable resistors.
Model: AS-SD1
This is a CN6 connector.

Data setter
The data setter lets you set parameters for your NX series with ease and also functions as a monitor.
Model: OPX-2A

Data setting software
The data setting software lets you set parameters for your NX series and monitor its operating condition using
a PC. The software comes with a PC interface cable [5 m (16.4 ft.)]. The cable is connected to the USB port
on the PC.
Model: MEXE02

Regeneration unit
Connect the regeneration unit if gravitational operation or other operations involving up/down movement, or
sudden starting/stopping of a large inertial load, will be repeated frequently.
Model Applicable product
RGB100 NXD20-A, NXD20-C
RGB200 NXD75-S

Battery
A battery needed when the absolute function is to be used in the position control mode.
Model: BAT01A

Driver cable
A shielded cable for driver I/O signals (36 pins) offering excellent noise resistance.
Model Length [m (ft.)]
CC36D1-1 1 (3.3)
CC36D2-1 2 (6.6)

Connector-terminal block conversion unit
Use this cable to connect the driver to a host controller via the terminal block. [Cable length: 1 m (3.3 ft.)]
Model Connect to
CC20T1 CN6 (analog I/O signals connector: 20 pins)
CC36T1 CN7 (I/O signals connector: 36 pins)