User manual

19 References
−171−
Parameter/operation data
OPX-2A screen
display
Name Setting range Initial value
− − − −
− − − −
APP-2-00 Analog speed command gain 0 to 5500 [r/min] 550
APP-2-01 Analog speed command clamp 0 to 500 [r/min] 10
APP-2-02 Analog speed command offset voltage −1.00 to 1.00 [V] 0
APP-2-06 Analog input signal automatic offset
0: Disable
1: Enable
0
rEv Operating speed 0 to 5500 [r/min] 0
− − − −
APP-2-03 Analog torque limit gain 0 to 300 [%] 30
APP-2-05 Analog torque limit offset voltage −1.00 to 1.00 [V] 0
APP-2-06 Analog input signal automatic offset
0: Disable
1: Enable
0
trq Torque limit 0 to 300 [%] 0
− − − −
tA Acceleration time 5 to 10,000 [ms / 1000 r/min] 100
td Deceleration time 5 to 10,000 [ms / 1000 r/min] 100
− − − −
SyS-1-05 Analog input signals
0: Disable
1: Enable
1
SyS-1-07 Motor rotation direction
0: + = CCW
1: + = CW
1
SyS-1-02
Operation selection after stopping in
speed control mode
0: Free
1: Servo lock
0
− − − −
APP-1-00 S-ON signal logic
0: Contact A (normally open)
1: Contact B (normally closed)
0
− − − −
− − − −
− − − −
APP-1-01 BRAKE signal logic
0: Contact A (normally open)
1: Contact B (normally closed)
1
APP-1-03 Output signal selection 2
0: ZSG2 output
1: ZV output
0
APP-1-06 Zero speed output band 1 to 5500 [r/min] 10
− − − −
APP-1-07 Attained speed output band 1 to 5500 [r/min] 30