User manual

19 References
−186−
Item Overview/condition
Electronic gear setting
error
The power was turned on when the resolution set by the electronic gear
and encoder output electronic gear was outside the specified range.
Sensor error during
operation
An encoder error was detected during operation.
Encoder communication
error
A communication error occurred between the driver and encoder.
Sensor error during
initialization
An encoder error was detected when the power was turned on.
Rotor rotation during
initialization
The motor output shaft rotated by 1/40th of a revolution during the
initialization following a power on.
Encoder EEPROM error Data stored in the encoder communication circuit was damaged.
Motor combination error A motor not supported by the driver is connected.
Descriptions of
alarms
EEPROM error Data stored in the driver was damaged.