User manual

8 Connection
−36−

Connector function table – Tension control mode
Pin
No.
Signal name Name
1 − −
2 GND
Ground connection
3 ASG+
4 ASG−
A-phase pulse line-driver output
5 BSG+
6 BSG−
B-phase pulse line-driver output
7 ZSG1+
8 ZSG1−
Z-phase pulse line-driver output
9 ALM+
10 ALM−
Alarm output
11 WNG+/MOVE+
∗
/MBC+
∗
12 WNG−/MOVE−
∗
/MBC−
∗
Warning output/ Motor moving output
∗
/
Electromagnetic brake control signal output
∗
13 − −
14 − −
15 READY+/AL0+
∗
16 READY−/AL0−
∗
Operation ready complete output/Alarm code output bit 0
∗
17 VLC+/AL1+
∗
18 VLC−/AL1−
∗
Speed limit output/Alarm code output bit 1
∗
19 ZSG2+/ZV+
∗
/AL2+
∗
20 ZSG2−/ZV−
∗
/AL2−
∗
Z-phase pulse open-collector output/ Motor zero speed
output
∗
/ Alarm code output bit 2
∗
21 GND
Ground connection
22 IN-COM
Input common
23 − −
24 ALM-RST Alarm reset input
25 − −
26 W-RESET Roll diameter reset input
27 M0
28 M1
29 M2
Data selection input
30 FREE
Shaft free input
31 CW+
32 CW−
CW input
33 CW+24 V CW input for 24 V
34 CCW+24 V CCW input for 24 V
35 CCW+
36 CCW−
CCW input
∗ The signal will become effective if the applicable setting has been changed using the data setter OPX-2A or the
data setting software MEXE02.