User`s manual

CONTROL KEYPAD 79(110)
7
7.3.3 Keypad control menu (M3)
In the Keypad Controls Menu, you can choose the control place, edit the frequency reference and change
the direction of the motor. Enter the submenu level with the Menu button right.
Code Parameter Min Max Unit Default Cust ID Note
P3.1 Control place 1 3 1 125
1=I/O terminal
2=Keypad
3=Fieldbus
R3.2 Keypad reference
Par.
2.1.1
Par.
2.1.2
Hz
P3.3
Direction (on
keypad)
0 1 0 123
0=Forward
1=Reverse
R3.4 Stop button 0 1 1 114
0=Limited function of Stop
button
1=Stop button always
enabled
Table 7-2. Keypad control parameters, M3
7.3.3.1 Selection of control place
There are three different places (sources) which the frequency converter can be controlled from. For each
control place, a different symbol will appear on the alphanumeric display:
Control place Symbol
I/O terminals
Keypad (panel)
Fieldbus
Change the control place by entering the edit mode with the Menu button right. The options can then be
browsed through with the Browser buttons. Select the desired control place with the Enter button. See the
diagram on the next page.
Figure 7-6. Selection of control place
I/O term
Keypad
Bus/Comm
P1
Î
P4
READY
I/Oterm
READY
I/Oterm
READY
I/Oterm
READY
I/Oterm
enter
READY
Keypad
STOP
STOP
STOP
STOPSTOP
Keypad control
Control Place
I/O Remote
Control Place
I/O Remote
Control Place
Keypad
Control Place
Keypad