User`s manual

CONTROL KEYPAD 93(110)

Upload parameters to keypad (To keypad, S6.3.2)

This function uploads all existing parameter groups to the keypad provided that the drive is stopped.

Enter the To keypad page (S6.3.2) from the Parameter copy menu. Push the Menu button right to enter the

edit mode. Use the Browser buttons to select the option All parameters and press the Enter button. Wait

until 'OK' appears on the display.

Figure 7-12. Parameter copy to keypad

Download parameters to drive (From keypad, S6.3.3)

This function downloads one or all parameter groups uploaded to the keypad to a drive provided that the

drive is in STOP status.

Enter the From keypad page (S6.3.3) from the Parameter copy menu. Push the Menu button right to enter

the edit mode. Use the Browser buttons to select either the option All parameters or Application parameters

and press the Enter button. Wait until 'OK' appears on the display.

The procedure to download the parameters from keypad to drive is similar to that of from drive to keypad.

See above.

Automatic parameter backup (P6.3.4)

On this page you can activate or inactivate the parameter backup function. Enter the edit mode by pressing

the Menu button right. Choose Yes or No with the Browser buttons.

When the Parameter backup function is activated NX control keypad makes a copy of the parameters of

the presently used application. Every time a parameter is changed the keypad backup is automatically

updated.

When applications are changed, you will be asked if you wish the parameters of the new application to be

uploaded to the keypad. For this to happen, push the Enter button. If you wish to keep the copy of the

parameters of the previously used application saved in the keypad push any other button. Now you will be

able to download these parameters to the drive following the instructions given in chapter 7.3.6.3.

If you want the parameters of the new application to be automatically uploaded to the keypad you have to

do this for the parameters of the new application once on page 6.3.2 as instructed. Otherwise the panel

will always ask for the permission to upload the parameters.

Note: Parameters saved in the parameter settings on page S6.3.1 will be deleted when applications are

changed. If you want to transfer the parameters from one application to another you have to upload them

first to the keypad.

READY

READY READY

enter

READY READY

Copy Parameters

Up to keypad

Select

CANCEL

CONFIRM

Up to keypad

Wait...

Up to keypad

All param.

CHANGE VALU