Assembly Instructions

PARTS INCLUDED:

(3) Left Angles (3) 4-1/2" Threaded Glides (3) LE-4 Leg Extenders

(3) Right Angles (3) 2-1/2" Threaded Glides

with threaded inserts

(3) Clamps w/thumbscrews (6) #8 Wood Screws

TO ASSEMBLE:

1. Measure the distance from the wood cleat to the floor.

2. Use the appropriate combination of glides and leg extenders to achieve the desired height. See combinations below:

3. Overlap one right angle over a left 2-1/2" Glide Only 4-1/2" Glide Only 4-1/2" Glide with (1) LE-4

angle and extend them to the 6"-8" Height Range 8"-10" Height Range 10"-14" Height Range

appropriate width. The holes at

the end of each piece should be

on the outside and on the top.

4. Center one clamp over the 2 angles,

and extend the angles to the proper

width so they rest on the cleats

of the wood rails.

5. Secure each end of the rails to the wood cleats with the wood screws, and unscrew the threaded

glide until it reaches the floor. Repeat with the other 2 sets of rails.

**Additional leg extenders are available to increase the height of the bed**