User`s manual

4.6 MODE SETTING

The AES-S3504UE with the device’s LEDs to indicate status. To select a storage policy in this mode

the first time that a new factory-shipped product is used, ensure that the hard disk drives are installed; turn off the

power before set the MODE SWITCH on the back of the AES-S3504UE to the desired Storage Policy.

To change the storage policy thereafter, set the MODE SWITCH to the desired position and press and hold the

recessed SETUP BUTTON, than power on to create the new virtual volume(s). Creating new virtual volumes will

destroy any existing data that existed on the previous volume.

Note: Before reconfiguring a volume, back up your data and delete previously defined partitions.

4.6.1 CLEAN MODE

The CLEAN MODE storage policy requires a minimum of 1 drive to implement.

1. Turn off the power.

2. Set the MODE SWITCH position to CLEAN.

3. Press and hold the recessed SETUP BUTTON.

Ver. 091015 AES-S3504UE User’s Manual