User`s manual

1 host port (eSATA or USB) to 4 Serial ATA hard disk drives.
Compatible with SATA Gen1 and Gen2 host controllers.
Compatible USB 2.0 specifications.
Embedded fast Storage Processor.
Ultra-fast 3Gbps host and device port capability.
Greater than 200MBps sustained reads in R0 mode (limited by drives and host controller).
1.3.2 SATA FEATURES
The AES-S3504UE provides the following Serial Advanced Technology Attachment (SATA) features:
1 eSATA host port to 4 SATA devices (Port Multiplier Functionality).
Auto-negotiation between SATA I (1.5Gpbs) and SATA II (3Gpbs).
Supports SATA II Gen2i and Gen2m (External SATA Connection, eSATA).
Supports Hot-Plug on CLEAN MODE.
Supports Native Command Queue (NCQ).
Supports PM aware and non-PM aware host on RAID mode.
Supports asynchronous signal recovery.
Supports spread spectrum clocking.
Supports BIST and loopback mode.
Supports 48-bit LBA addressing.
Supports ATAPI drives.
Supports host control of hard disk drive staggered spin-up.
Supports Asynchronous Notification.
Output swing control and automatic impedance calibration for SATA II PHY.
1.3.3 USB FEATURES
The AES-S3504UE provides the following Universal Serial Bus (USB) features:
1 USB 2.0 host port to 5 SATA devices.
Operates at USB full and High-speed rates (12 ~ 480Mb/s).
OS independent, Driverless, Auto Configuration.
Support USB High-Speed and Full-Speed Operation.
Supports and compatible with OHCI/UHCI/EHCI hosts.
Support Mass Storage Class.
Support on line USB firmware update.
Compliance with USB 2.0 electrical specification.
Compliance with USB Mass Storage Class, Bulk-Only Transport Specification.
1.4 SPECIFICATIONS
Four 3.5-inch SATA HDDs to a standard B type USB or eSATA interface with door cover.
Power, PC Link, and four HDD LEDs.
Design based on the JMicron JMB394 and JM20339 controllers.
Support Clean, Large, Clone, R0, R1, R3, R5, R10 modes.
Metal chassis (SECC) and plastic panel frame (ABS) design.
Ver. 091015 AES-S3504UE User’s Manual
6