Installation guide

NeJpfuJTip:Pushuponfrontofdishwashertoraisedishwasher

offthegroundtoadjustfrontlegs.Withsomeinstallations,it

maybeeasiertoadjustthefrontlegusingthe3/16"hexhead

socketoradjustablewrench.

Placelevelagainsttopfrontopeningoftub.Checkthat

dishwasherislevelfromsidetoside.Lfdishwasherisnotlevel,

adjustfrontlegsupordownuntildishwasherislevel.

Coppertubingonly:Slidenutthenferruleontocoppertubing

about1"(2.5cm).

NOTE:Toavoidvibrationduringoperation,routethewater

supplylinesothatitdoesnottouchthedishwasherbase,frame

ormotor.

using copper or flexible line

Copper tubing only: Put the tubing into the 90 ° elbow fitting as

far as it will go (the copper tubing bends and kinks easily). Slide

the nut and ferrule forward and start the nut onto the elbow

threads.

Flexible braided connection: Secure nut to elbow using %" open-

end wrench or adjustable wrench.

NOTE: Do not use Teflon <_tape with compression fittings.

Hold the 90 ° elbow fitting still with one adjustable wrench and

tighten the nut with second adjustable wrench.

NeJpfuJ Tip: Use a %" open-end wrench for easier access to

tighten connection.

Place paper towel under 90 ° elbow fitting. Turn on water

supply and check for leaks. If leak occurs, repeat previous step.

If needed, see website for animated representation of this step.

Visit ww_v.amana.com/watersupply under FAQ tab.