Installation guide

Green clamp

Black drain hose

connector --

Drain hose

Drain hose stop

Stop

Place towel under drain hose to catch any water in drain hose.

Place the small green drain hose clamp onto the small end of

the drain hose. Push the new drain hose into the black drain

hose connector up to the drain hose stop.

Using pliers, squeeze open the small green drain hose clamp

and slide onto connector between stops.

Once connected, remove towel.

If needed, see website for animated representation of this step.

Visit www.amana.com/drain under FAQ tab.

NOTE: If the power supply cord was connected earlier

proceed to "Secure Dishwasher in Cabinet Opening" section.

_;_[_[_#__[_[___

Option B, Direct Wire:

Route cable so that it does not touch dishwasher motor or

lower part of dishwasher tub. Pull cable through cable clamp in

terminal box.

Select UL Listed/CSA Approved twist-on wire connectors

(not included) rated to connect your household wiring to 16-gauge

dishwasher wiring.