Installation guide

THEF_CTREALCONNECF|ONS
SEE THE ELECTRICAL REQUIREMENTS SECTION
CAUTION: Verify power to dishwasher is off at source.
O Remove terminal box covet:
Ix order to secure the power supply cable, a ULlisted strain relief nmst be used to secure
the power supply to the back of tet'mina[ box,
Q Strip approximatdy 3/8" (.09 em) of"insulation fl'om incoming power supply wires. Connect
n ....... 27- ZZ
.2-_--_ ol
O Terminal I_o_
these wires to wires from dishwasher wire ]harness located in the terminal box. Connect
wires using the appropriate size wire nuts, twisting and tightening securely over the wire
connections. Connect white to white and black to black. Black to Black
Attach external grom)d wire frmn be]hindwasher of greet) grmmding screw. If an external
groundwh'e is used. insert the wire through the cable clamp and attach behind washer of
the green gro,nding screw. Attach the other end of external gro,nd wire to a s,itabie
external ground. If a question arises, refer to yore' local
electrical codes,
to White
Seem'e the strain relief and replace the termina! box covet:
StraiJJ Relief
IIOORUP
CHECKLOCALPLUMBINGCODESFOR APPROVEDPLUMBING
......... =PROCEDURESANDACCESSORIES.ALLPLUMBINGSHOULDBEDONE
IN ACCORDANCE WITH NATIONAL AND LOCAL CODES.
Connect water supply line to water valve, Minimum 3/8" 0.D. copper tubing or equivalent.
S}I[UTOFFVALVE:Instal[ a hand shutoff valve it) the water supply line ix an accessible location, such as m)der the sink The shutoff is optional,
but recmnmended and may be req_fired by local codes. Connections are pt'eferab[e located toward the left side of dishwasher: Care should be taken
to route plumbing away frmn motor and blower (if equipped), DONOT make these connections until the dishwasher is it) position,
Care s]houldbe taken to protect dishwas]her and water lines leading to dishwasher frmn freezing, Damagefrom freezing is not coveredby the
warranty.
C]Mckdrain hose cmmection for leaL