Manual

Control Panel
A B
C D E F G H
\
\
\
\
\
J K L M N
The control panel is designed for ease in programming. The displaywindow on the control shows time of day,timer and oven functions.
Control panel shown includes Convect and other model specific features. (Styling may vary depending on model.)
Conve_
Bake
Broil
Cancel
Clock
Oven Light
Favorite
Clean
Cook & Hold
KeepWarm
Delay
Number Pads
Autoset
Timer
Use for convection baking and roasting.
Use for baking and roasting.
Use for broiling and top browning.
Cancels all operations except Timer
and Clock.
Use to set time of day clock.
Use to turn the oven light on or off.
Use to set and save a specific Cook &
Hold procedure.
Use to set self-clean cycle.
Bakes for a preset time, then holds food
warm for 1 hour.
Use to keep cooked food warm in oven.
Programs the oven to start baking at
a later time.
Use to set time and temperature.
Use to quickly set temperatures.
Sets Timer.
Using the Touchpads
Pressthe desired pad.
Pressthe number pads to enter time or temperature.
Pressthe Autoset 0 pad to enter temperature.
• A beep will sound when any pad is touched.
• A double beep will sound if a programming error occurs.
Note: Four seconds after pressing the number pads or
the Autoset 0 pad, the time or temperature will automati-
cally be entered. If more than 30 seconds elapse between
touching a function pad and the number pads or the
Autoset Opad, the function will be canceled and the
display will return to the previous display.
8
Clock
The clock can be set to display time in a 12-hour or 24-hour
format. The clock is set at the factory for the 12-hour format.
To change the clock to
24=hour format:
1. Press and hold tile Cancel and Favorite
pads for three seconds.
• 12 Hr flashes in the display.
2. Press the Autoset O pad to select 24 Hr;
3,
pressagaintoselect,2.r ............iiiiii!i, i !iiiiiiiiiiiii! iiiiiii
Set the time of day following the directions ;Aut;ese_;
in the To set the Clock section.
To set the Clock:
.......;;;: ]]
1. Press tile Clock pad.
• The time of day flashes in the display.
2. Press the appropriate number pads to set the time of day.
• Colon flashes in the display.
3. Press the Clock pad again or wait four seconds.
• The colon will remain on.
When electrical power is supplied or after a power
interruption, the last clock time before power was
interrupted will flash.
cont.