Installation Instruction

ManualsBrandsAmana ManualsAppliances30 in. 4.8 cu. ft. Electric Range in Black

INSTALLATION INSTRUCTIONS

30" (76.2 CM) FREESTANDING ELECTRIC RANGES

W11047681A

Table of Contents

IMPORTANT:

Save for local electrical inspector's use

RANGE SAFETY .............................................................................2

INSTALLATION REQUIREMENTS .................................................3

Tools and Parts ............................................................................. 3

Location Requirements ................................................................3

Electrical Requirements - U.S.A. Only .........................................5

INSTALLATION INSTRUCTIONS ...................................................6

Unpack Range..............................................................................6

Install Anti-Tip Bracket .................................................................6

Electrical Connection - U.S.A. Only .............................................8

Verify Anti-Tip Bracket Is Installed and Engaged ......................12

Level Range ................................................................................13

Warming Drawer or Premium Storage Drawer ..........................13

Storage Drawer ..........................................................................14

Oven Door ..................................................................................14

Complete Installation .................................................................14

Moving the Range ......................................................................15

Summary of content (16 pages)

PAGE 1
INSTALLATION INSTRUCTIONS 30" (76.2 CM) FREESTANDING ELECTRIC RANGES Table of Contents RANGE SAFETY..............................................................................2 INSTALLATION REQUIREMENTS..................................................3 Tools and Parts..............................................................................3 Location Requirements.................................................................3 Electrical Requirements - U.S.A. Only....................................
PAGE 2
RANGE SAFETY Your safety and the safety of others are very important. We have provided many important safety messages in this manual and on your appliance. Always read and obey all safety messages. This is the safety alert symbol. This symbol alerts you to potential hazards that can kill or hurt you and others. All safety messages will follow the safety alert symbol and either the word “DANGER” or “WARNING.
PAGE 3
INSTALLATION REQUIREMENTS Tools and Parts Location Requirements Gather the required tools and parts before starting installation. Read and follow the instructions provided with any tools listed here. IMPORTANT: Observe all governing codes and ordinances. ■■ It is the installer’s responsibility to comply with installation clearances specified on the model/serial rating plate. The model/serial rating plate is located on the frame behind a top corner of the door or either side of the drawer.
PAGE 4
Product Dimensions Cabinet Dimensions Cabinet opening dimensions shown are for 25" (64.0 cm) countertop depth, 24" (61.0 cm) base cabinet depth and 36" (91.4 cm) countertop height. IMPORTANT: If installing a range hood or microwave hood combination above the range, follow the range hood or microwave hood combination installation instructions for dimensional clearances above the cooktop surface. A freestanding range may be installed next to combustible walls with zero clearance.
PAGE 5
Electrical Requirements - U.S.A. Only If codes permit and a separate ground wire is used, it is recommended that a qualified electrical installer determine that the ground path and wire gauge are in accordance with local codes. Do not use an extension cord. Be sure that the electrical connection and wire size are adequate and in conformance with the National Electrical Code, ANSI/ NFPA 70-latest edition and all local codes and ordinances.
PAGE 6
INSTALLATION INSTRUCTIONS Unpack Range WARNING Install Anti-Tip Bracket WARNING Excessive Weight Hazard Use two or more people to move and install range. Failure to do so can result in back or other injury. 1. Remove shipping materials, tape and film from range. 2. Remove oven racks and parts package from inside oven. 3. Do not remove the shipping base at this time. Tip Over Hazard A child or adult can tip the range and be killed. Install anti-tip bracket to floor or wall per installation instructions.
PAGE 7
Floor Mounting Rear position 5. Using the Phillips screwdriver, mount anti-tip bracket to the wall or floor with the two #12 x 15⁄8" screws provided. 6. Move range close enough to opening to allow for final electrical connections. Remove shipping base, cardboard or hardboard from under range. 7. Move range into its final location, making sure rear leveling leg slides into anti-tip bracket. Front position Diagonal (2 options) Wall Mounting 8.
PAGE 8
Electrical Connection - U.S.A. Only Direct Wire Power Supply Cord WARNING WARNING Electrical Shock Hazard Electrical Shock Hazard Disconnect power before servicing. Disconnect power before servicing. Use a new 40 amp power supply cord. Use 8 gauge copper or 6 gauge aluminum wire. Plug into a grounded outlet. Electrically ground range. Failure to follow these instructions can result in death, fire, or electrical shock.
PAGE 9
Style 2: Direct wire strain relief ■■ Remove the knockout as needed for the flexible conduit connection. ■■ Assemble a UL listed conduit connector in the opening. If your home has: And you will be connecting to: Go to Section: 3-wire direct A circuit breaker box or fused disconnect 3-wire connection: Direct wire ³⁄₈" (1.0 cm) 3" (7.6 cm) A 4-wire connection: Power Supply Cord Use this method for: B A. Removable retaining nut B.
PAGE 10
4. Use a Phillips screwdriver to connect the green ground wire from the power supply cord to the range with the groundlink screw and ground-link section. The ground wire must be attached first. 5. Use ³⁄8" nut driver to connect the neutral (white) wire to the center terminal block post with one of the 10–32 hex nuts. A 2. Use ³⁄8" nut driver to connect the neutral (white) wire to the center terminal block post with one of the 10–32 hex nuts. A E F D B B C E C A. 10–32 hex nut B. Line 2 (red) C.
PAGE 11
1. Part of metal ground strap must be cut out and removed. Bare Wire Torque Specifications Attaching terminal lugs to the terminal block - 20 lbs-in. (2.3 N-m) A B C A. Metal ground strap B. Discard C. Ground-link screw 2. Use a Phillips screwdriver to remove the ground-link screw from the back of the range. Save the ground-link screw and the end of the ground link under the screw. 3. Pull the wires through the strain relief on bottom of range.
PAGE 12
2. Attach terminal lugs to line 2 (red), bare (green) ground, and line 1 (black) wires. Loosen (do not remove) the setscrew on the front of the terminal lug and insert exposed wire end through bottom of terminal lugs. Securely tighten setscrew to torque as shown in the following Bare Wire Torque Specifications chart. A B C D A. B. C. D. E. E Verify Anti-Tip Bracket Is Installed and Engaged On Ranges Equipped with a Storage Drawer: 1. Remove the storage drawer. See the “Storage Drawer” section. 2.
PAGE 13
6. Repeat steps 1 and 2 to ensure that the range foot is engaged in the anti-tip bracket. If the rear of the range lifts more than ½" (1.3 cm) off the floor without resistance, the anti-tip bracket may not be installed correctly. Do not operate the range without antitip bracket installed and engaged. Please reference the “Assistance or Service” section of the Use and Care Guide, or the “Warranty” section of the User Instructions, to contact service.
PAGE 14
Storage Drawer (on some models) The storage drawer can be removed. Before removing, make sure drawer is cool and empty. 3. Close the oven door as far as it will shut. 4. Lift the oven door while holding both sides. Continue to push the oven door closed and pull it away from the oven door frame. To Remove: 1. Pull the storage drawer straight back to the drawer stop. To Replace: 1. Insert both hanger arms into the door. A A. Drawer stop notch 2. Lift up the front of the drawer and pull the drawer out.
PAGE 15
Moving the Range WARNING For direct-wired ranges: WARNING Electrical Shock Hazard Tip Over Hazard A child or adult can tip the range and be killed. Disconnect power before servicing. Install anti-tip bracket to floor or wall per installation instructions. Replace all parts and panels before operating. Slide range back so rear range foot is engaged in the slot of the anti-tip bracket. Re-engage anti-tip bracket if range is moved. Do not operate range without anti-tip bracket installed and engaged.