Installation Instructions

19
To Convert Surface Burners (Propane Gas to Natural
Gas)
1. Remove burner cap.
2. Remove the burner base.
3. Apply masking tape to the end of a 9/32" (7 mm) nut driver to
help hold the gas orice spud in the nut driver while changing
it. Press nut driver down onto the gas orice spud and remove
by turning it counterclockwise and lifting out. Set gas orice
spud aside.
4. Gas orice spuds are stamped with a number on the side or
top. Replace the propane gas orice spud with the correct
Natural gas orice spud.
Refer to the following chart for the correct Natural gas orice
spud placement.
Natural Gas Orice Spud Chart
Burner Rating Size (mm) ID Number
18,000 BTU 2.00 200AM
17,000 BTU 1.96 196AM
15,000 BTU 1.80 180AM
9,500 BTU 1.40 140AM
8,000 BTU 1.30 130AM
5,000 BTU 1.00 100AM
NOTE: Refer to the model/serial/rating plate located on the oven
frame behind the top right-hand side of the oven door for proper
sizing of spuds for each burner location.
5. Place propane gas orice spuds in the orice spud bag.
IMPORTANT: Keep the propane gas orice spuds in case
of reinstallation with propane gas.
6. Replace the burner base.
7. Replace burner cap.
8. Repeat steps 1 to 7 for the remaining burners.
To Convert Oven Bake Burner (Propane Gas to
Natural Gas)
1. Remove the oven racks.
2. Remove 2 screws at the rear of the oven bottom.
3. Lift the rear of the oven bottom up and back until the front of
the panel is away from the front frame. Remove from oven
and set it aside on a covered surface.
A. Burner cap
B. Burner base
C. Alignment pins
D. Igniter electrode
E. Gas tube opening
D
E
C
B
A
A
B
C
D
A. Igniter electrode
B. Orice spud
C. Orice spud holder
D. Screws
A. Stamped number
XXX
XXX
A
A
B
A. Screws
B. Oven bottom