Installation guide

INSTALLATIONINSTRUCTIONS
t'O0_S 3_J
Tools Needed
Gather the required tools and parts before starting installation.
Read and follow the instructions provided with any tools
listed here.
• Measuring tape • Drill
• Pencil • 7/64" drill bit
• Phillips screwdriver • Tape
Parts Supplied
Duct base Trimkit frame
Left duct Templates 1 and 2
Bottom bracket Topbracket
13/16" screws (2) 9/16" screws (16) 1/2" screws (4 - painted)
The microwave oven may be installed over a built-in oven. If
installing over a built-in oven, make sure there is a minimum of 3"
(7.6 cm) between the top of the lower oven cutout and the
microwave oven cutout floor.
The microwave oven may also be installed in a cabinet by itself
(without a built-in oven below). For best usability, we recommend a
minimum distance of 36" (91.4 cm) from the floor to the cutout floor.
Make sure the surrounding cabinetry has clearance to open and
close freely. Allow a clearance of at least 1" (2.5 cm) below the
cutout floor (3" [7.6 cm] for installation above a built-in oven), and
a clearance of at least 2" (5.1 cm) above the cutout opening.
1"
(2.5cm) f
I
36"
(91.4 c
t
3"
-(7.6 crn)
A. Upper cabinet D. Lower cabinets
B. Microwave oven cutout E. Floor
C. Lower oven cutout
(42.9
3"
(7.6
11/16Jt
(1.8cm)
B
A. Trim kit frame overhang
B. Cutout for lower oven
NOTES:
• Height, width and depth measurements have _+1/16" (2 mm)
tolerance.
• 3" (7.6 cm) minimum dimension is from lower oven cutout
ceiling to microwave oven cutout floor.
• Trim kit frame extends 11/16" (1.8 cm) below, and 19/16''
(4.0 cm) above the cutout opening.
_ ,_ _, i _ _ _ _ , _ _,,_,_ _ ,-_
t
19_/8,,
(48.6 crn)
!
26_,,
24" (61.0 c_)
17/W ' (3.7 crn)*
27/8" (7.3 crn)**
(2.2 crn)
3" (7.6 crn)
*27" (68.6 cm) trim kit
**30" (76.2 cm) trim kit
2