Installation guide

STEP 3: Prepare The Venting Blower
4. Reassemble the blower wire. See Figure 14.
5. Rotate the unit so that the exhaust ports face the rear of the cabinet. See Figure 16. When you insert blower unit,
blower wire must be like figure 15.
6. Place blower unit back into cabinet. Check that the exhaust ports face towards the rear of the cabinet. See Figure 16.
7. Reattach the blower plate to cabinet so the exhaust ports and blower plate opening are aligned. Attach with one blower
unit mounting screw and then one blower plate mounting screw. See Figure 17.
Figure 14 Figure 15 ports
Roof-Vented Installation:
1. Remove one blower unit mounting screw and one or two
blower plate screw(s). Remove the blower plate from cabinet.
See Figure 18.
2. Use side cutter or thin snips to cut and remove knockouts "A"
from Blower plate. Discard knockouts. Be careful not to distort
the plate. See Figure 19.
blower
-unit
exhaust
exhaust
ports Figure 16
blower plate
'_-- mounting screw
°:nit__ er plate
blower u /
__ _-_- back plate
. I.PT-_J%._ blower unit
blowerunlt_ L-_fJ _ mounting screw
exnausr porls _"
Figure 17
3. Carefully lift the blower unit out of the microwave oven.
4. Rotate blower unit 90° so the exhaust ports face the upper of
the cabinet. See Figure 20.
5. Reassemble the blower wire.
6. Place blower unit back into microwave oven.
7. Reattach blower plate to microwave oven. Attach with the one
blower unit mounting screw and then the one or two blower
plate mounting screw(s). See Figure 21.
8. Attach the exhaust adapter to the blower plate by sliding it into
the Guide. See Figure 22.
__ blower plate
mounting screw
blower unit
_:__ blower plate
back plate
parts'B"_ _ mountingscrew
. Figure 18
blower plate /
)lower
unit
Figure 20
blower unit
blower plate
ounting screw
" _wer unit
blower plate
Figure 21
Figure 19
Exhaust
,_ adaptor
ofoven
mountingscrew
Figure 22
12