Installation Instructions

11
Installing the tubing clips
Refer to the side diagram for the following
steps.
1. Remove the seven hex-head screws from the rear access
cover, then remove the cover and set it aside.
NOTE: If you have a later unit with a metal panel, (see
DETAIL A), remove the hex-head screw from the access
cover. Discard the cover and its screw. Do not remove the 7
hex-head screws from the larger rear access cover.
2. Peel the backing from the adhesive sides of the tubing clips.
Press the clips against the back of the cabinet in the right
channel at the approximate locations shown in DETAIL B.
Center the clips between the ll tube and the top of the
access opening. Alternate ll tube designs ares shown in
DETAIL C and DETAIL D (for 11 Cubic Foot Top Freezer
Models with Fill Tube and Bracket Fill Tube).
If you have a bottom freezer, proceed to page 12. If you have a
side-by-side (SXS) or a top freezer unit, proceed to page 13.
Installing the tubing clips
Right
channel
DETAIL B
Tubing
clip
Tubing
clip
Top and SXS
freezers
Bottom
freezers
Fill tube for bottom
freezer models
Remove 7 hex-
head screws
from rear
access cover
Metal panel
Remove hex-
head screw
from rear
access cover
DETAIL A
Access
cover
DETAIL C
Alternate
fill tube
design
DETAIL D
Fill tube with
bracket fill tube
(11 Cubic Foot Top
Freezer Models)
Fill Tube
Fill tube for
top and SXS
freezers only
Bracket
Fill Tube