Installation Instructions

8
Refer to the side diagram for the following step. You will be
working inside the freezer compartment.
1. Install the plastic extension by sliding it over the ll tube as
far as it will go.
Refer back to the side diagram for the following step.
2. Position the wiring harness so that it is through the slot in the
wiring cover. Insert the tab at the back of the wiring cover
into the freezer liner slot. Press the pin on the side of the
wiring cover into the hole in the side of the freezer liner so
it locks into place. Secure the wiring cover with the phillips
screw you removed earlier.
Proceed to “Installing the tubing clips” on
page 11.
Fill tube
Long fill
tube extension
Wiring harness
Slot
Installing the long ll tube extension
Tab
Insert tab
into slot
Break off and discard
Wiring
cover
Wiring
harness
Hole
Slot
Phillips
screw
Pin
Insert pin
into hole
Hole cover
Replacing the ice maker wiring cover