Service manual

Component Testing Information
!
WARNING
To avoid risk of electrical shock, personal injury, or death, disconnect power to oven before servicing, unless
testing requires it.
RS2310005 Rev. 0 12
General Component Test Procedure Results
Bake burner Verify gas is supplied.
Orifice adjusted for Natural or LP.
Check for obstructions or
contamination in ports.
Broil burner assembly Verify gas is supplied.
Orifice adjusted for Natural or LP.
Check for obstructions or
contamination in ports.
Venturi
−
surface
burner
Shutter settings:
Nominal
Tol.
±
.125
"
1/8
"
.031
"
1/32
"
L
AB
A1
B1N
Spark module 4 + 0 Test for voltage at terminals L and N
Check spark leads.
Check for arcing to chassis.
120 VAC
See wiring diagram.
Continuity in lead, no continuity to chassis.
Temperature sensor Measure resistance.
No Bake/Broil ...................................
Approximately
1090
O
at room temperature 75
º
F,
1650
O
at 350
º
F,
2600
O
at 850
º
F
If sensor is open when range is powered
up the F-3 code will not be displayed.
Check sensor resistance and connections.
Knob Control
PIN 1
E4
E2
E1
PIN 1
J2
J1
Electronic range
control
Control will run a 30
second diagnostic
scan on power up.
Door lock will cycle
and door lock light will
blink.
Measure voltage at terminals
J2
−
3 (L1) and E2 (NEU) ..................
Relay drive requirements
Bake

J2
−
1 to NEU.........................
Broil

J2
−
5 to NEU.........................
Bake...............................................
Broil................................................
Clean
Stage 1...........................................
Stage 2...........................................
Time (Adjustable) ...........................
Failure codes
:
F1-Control malfunction.....................
F2-Oven over temperature ...............
F3-Oven temperature sensor
Open or Shorted..........................
F9-Door latch circuit malfunction......
120 VAC should be indicated, verifying
voltage to control.
120 VAC, if not replace control.
120 VAC, if not replace control.
100% bake element
100% broil element
Time controlled 30 minutes 100% broil
Same element control as bake mode
2 hours minimum to 4 hours maximum
Verify voltage to control.
If no voltage is present, check wiring.
If voltage is present, replace control.
Check sensor resistance and wiring.
Replace control if sensor and wiring are
good.
Check sensor resistance and wiring.
Replace sensor, if wiring is good.
Check latch switch and associated wiring.