Service manual

RS2310005 Rev. 0 16
Troubleshooting Procedures
WARNING
!
To avoid risk of electrical shock, personal injury or
death, disconnect power and gas supply before
servicing, unless testing requires it.
Bake and Broil Burners
Problem Possible Cause Correction
Flame blows away from
burner.
•
Too much air.
•
Gas pressure too high.
•
Draft around cooktop area.
•
Slightly close air shutter to burner.
•
Verify correct gas pressure.
•
Eliminate source of draft.
Flames flash back into
mixer head.
•
Too much air.
•
Close air shutter slightly.
Floating flame.
•
Blocked flue or burner.
•
Not enough air.
•
Check for possible blockage in burner.
•
Open air shutter.
Gas smell.
•
Leak in pipe joints.
•
Valve leak.
•
Regulator plug loose.
•
Verify gas connections and tighten if
necessary.
•
Check valves and replace if necessary.
•
Check and tighten regulator plug.
Gas valve opens but
bake and broiler burners
do not ignite. Delayed
ignition.
•
Bake/Broil ignitor positioned too far
from burner.
•
Range is not properly converted for
LP gas.
•
Low gas pressure.
•
Misalignment of orifice and burner.
•
Partial blockage of orifice, burner or
feed tube.
•
Reposition Bake/Broil ignitor closer to
the burner.
•
Verify correct conversion procedures.
•
Verify correct gas pressure.
•
Check alignment of burner and orifice
and align correctly.
•
Check for blockage or burr in orifice.
•
Clean burner.
Oven light does not
operate.
•
Failed oven lamp.
•
Failed light switch.
•
Failed wiring.
•
Failed light socket.
•
Check lamp and replace if necessary.
•
Check switch contacts.
•
Check for broken wires and loose or
dirty connections.
•
Check light socket for continuity.
Broil shuts off
•
Normal
•
Broil interrupted when door is open for
more than 3 minutes.