Service manual

Disassembly Procedures
Disconnect power source and shut off gas supply before
servicing, unless testing requires it.
WARNING
!
19 RS2310005 Rev. 0
Door Latch Motor, Plunger Light Switch,
Latch Switch, Rod, and Door Catch
1. Disconnect electrical supply to range.
2. Perform cooktop removal instructions.
3. Move the two left top burner venturies out of the way
to access latch mechanism.
4. Remove screws in front and on right side securing
latch mechanism to range front frame and galvanized
insulation retainer.
5. Carefully maneuver assembly to the rear to clear door
catch and light switch plunger.
6. Move assembly to the left side then lift up on the right
side. After clearing the insulation retainer turn
assembly upside down to access screws securing
components to mounting plate.
7. Reverse procedures to reassemble.
Oven Door Gasket
The braided fiberglass oven door gasket is clipped at
intervals in holes around the front of the oven liner then
inserted into a
3
/
8
–inch holes at the bottom.
A 6
1
/
2
–inch gasket void at the bottom does not interfere
with sealing of oven to door.
1. Unclip original gasket from front frame and pullout
ends from
3
/
8
–inch holes.
2. Remove two knurled nuts securing oven bottom in
position. Remove oven bottom.
3. Divide oven gasket in half and insert center clip into
top center hole in the front frame. Proceed inserting
clips left and right.
4. Push gasket through the
3
/
8
–inch holes. From behind
the holes gently pull on the gasket ends to provide a
neat appearance. Then tuck the ends between cross
brace and front frame. Assure that gasket ends are
not visible through air intake slots. If so, reposition
prior to installing oven bottom and oven door.
Storage Drawer Tracks
1. Remove storage drawer from unit.
2. Remove bolt and nut securing track to the chassis
(located in the front of the unit).
3. Slide track backwards and then forward to remove
track.
Bake Burner Ignitor and Broiler Burner
Ignitor
1. Turn off electrical supply to oven.
NOTE: For bake burner ignitor, remove oven bottom.
2. Remove screws securing ignitor bracket to burner.
3. Pull ignitor and wires forward about 6 inches.
4. Disconnect wires on old ignitor.
5. Handle new ignitor by ceramic base and transfer to
old ignitor bracket.
6. Connect new ignitor wires.
7. Push wires/connector backward through both holes
as far to the “outside” as possible.
8. Reverse procedures to reattach ignitor bracket.
Sensor, Oven Control
1. Remove screws securing SENSOR to oven liner.
2. Gently pull wires forward to access the two pin
polarized disconnect plug.
3. Disconnect and reconnect new sensor.
4. Reverse procedure to reassemble.
Bulb, Oven Light, and Oven Light Socket
1. Disconnect electrical supply to oven.
2. Wearing protective gloves unscrew the knurled
“mason jar” lens cover counterclockwise about 3/4
turn and remove. Unscrew old oven light bulb.
3. Remove screws securing oven light socket to the
oven cavity.
4. Pull oven light socket out through the front and
disconnect wire terminals from socket.
5. Reverse procedures to reassemble.