Service manual

Disassembly Procedures
Disconnect power source and shut off gas supply before
servicing, unless testing requires it.
WARNING
!
21 RS2310005 Rev. 0
Flue
1. Disconnect electrical supply to range.
2. Turn off or disconnect gas supply to range.
3. Using a floor protection pad slide range forward.
On a solid pipe connection the pipe must be first
disconnected from pressure regulator inlet
connection, accessed through storage door area.
4. Remove screws securing top burners to maintop.
5. Raise maintop in front and slide maintop forward,
leaving ignitor wires connected.
6. Remove first set of screws securing flue, located
under maintop.
7. Remove broil burner, see Broil Burner procedure.
8. Remove second set of screws securing flue, located
on the inside of the oven cavity.
9. Remove lower access panel on back of unit.
10.Remove backguard shield from backguard brackets.
11.Drill two holes
5
/
16
–inch in the back of the rear
insulation retainer to gain access to screws securing
flue.
5/16"
Holes
12.Remove third set of screws securing flue to exterior
of the oven cavity.
Leveling Leg Bracket
• Remove screws securing bracket to chassis.
Front Frame and Oven Liner
Front Frame and Oven Liner are NOT field replaceable
on these units.
Side Panel
1. Remove cooktop, see Cooktop procedure steps 1– 6.
2. Remove lower access panel, located on the rear of
unit.
3. Remove screws securing backguard bracket to side
panel.
4. Remove oven door from unit and slide oven drawer
outward to gain access to screws.
5. Remove screws securing side panel to oven chassis.
Screws are located on top, front, and back of unit.
6. Remove side panel by pulling outward on the back of
panel and sliding panel forward.
7. Reverse procedure to reassemble.
Power Cord
1. Slide unit outward to gain access to power cord.
2. Unplug power cord from receptacle.
3. Remove screw securing power cord to unit chassis.
4. Disconnect power cord.
5. Reverse procedure to reassemble.