Service manual

RS2310005 Rev. 0 A–2
LP/Propane
Conversion
Converting for Use with
LP/Propane Gas
Your range is factory set for use with natural gas. If LP/Propane gas use is
desired, the range must be converted. Gas supply should be turned off
prior to conversion.
Converting Pressure Regulator for Use with
LP/Propane
1. Remove storage drawer from front of range.
Refer to Removing Storage Drawer section in Owner’s Manual.
2. Locate pressure regulator.
3. Remove the pressure regulator cap with a wrench.
4. Pull plastic insert from pressure regulator cap.
• Plastic insert is placed tightly in cap.
• Pliers or a wrench may be used to carefully remove the insert.
5. Reverse plastic insert and carefully push
plastic insert firmly into hole in pressure
regulator cap.
• Insert stem must show LP rightside up.
• Long end of insert should be inserted into
cap as shown.
6. Place pressure regulator cap on pressure
regulator and tighten.
• Insert should not disturb
spring in body of regulator.
7. Verify regulator shutoff valve
is in OPEN position.
8. Replace storage drawer.
Refer to Owners Manual and Installation
Instructions for safety statements.
Keep these instructions for future reference.
Installation must conform to all local,
municipal and state building codes and
local utility regulations.
pressure
r
egulator cap
plastic
insert
spring location
LP
Questions?
Refer to Owners Manual
or call Amana Consumer Affairs Department
1-800-843-0304
oven shutoff valve
OPEN position
WARNING
!
To avoid electric shock that can
cause personal injury or death,
disconnect main electrical supply
to range before servicing.