Service manual

A–3 RS2310005 Rev. 0
Converting Surface Burners for Use with LP/Propane
Converting Oven Burner for Use with LP/Propane
Converting Broiler Burner for Use with
LP/Propane
1. Open oven door and locate broiler burner on oven ceiling.
2. Locate orifice spud on broiler fitting in the back of oven.
3. Using a
1
/
2
" open end wrench turn orifice hood clockwise initially 1 turn
and adjust as necessary, or until snug.
• A mark may be placed on the orifice hood so turns can be easily
counted.
• Do not over tighten orifice hoods. If orifice hoods are over tightened,
gas supply can be cutoff or orifice hoods can strip.
4. Close oven door.
• Air flow may need to be adjusted to oven burner flame after
conversion. Refer to Owner’s Manual for instructions.
1. Remove storage drawer.
• Refer to Removing Storage Drawer section in Owner’s Manual.
2. Locate bake burner orifice hood.
3. Using a
1
/
2
" open end wrench turn orifice
hood clockwise 2 to 2
1
/
2
turns or until snug.
• A mark may be placed on the orifice hood
so turns can be easily counted.
• Do not over tighten orifice hoods. If
orifice hoods are over tightened, gas supply
can be cutoff or orifice hoods can strip.
4. Verify fuel supply shut off valve is in OPEN
position on pressure regulator.
5. Replace storage drawer.
• Air flow may need to be adjusted to oven
burner flame after conversion. Refer to
Owner’s Manual for instructions.
burner knob
p
ivot
p
oint
orifice hood
air shutter
1. Remove 4 burner control knobs from range.
• 2 screws are exposed on the burner control panel.
2. Remove 2 screws from burner control panel.
• Panel drops slightly after screws are removed.
3. Grasp bottom of burner control panel, gently lift and pull
out panel until clear of burner valve stems.
• After burner control panel clears valve stems,
continue to roll panel until free from range. Set aside.
• Gas valve and orifice hood are visible after burner
control panel is removed.
4. While facing range front, turn orifice hoods
counterclockwise 1½ to 2 turns or until snug.
• A mark may be placed on the orifice hood so turns can be
easily counted.
• Use ½ inch open end or 90° offset open end wrench.
• Do not over tighten orifice hoods. If orifice hoods are over
tightened, gas supply can be cutoff or orifice hoods can strip.
5. Open air shutter fully using a flat blade screwdriver and moving
the shutter back to the orifice hood.
6. Reassemble burner control panel after adjusting air shutter.
• Refer to Adjusting Surface Burner Flame section in Owner’s Manual.
open
close
orifice
hood
orifice
hood