Owner`s manual

27
This manual is the property of Burger King Corporation and may be used only in a manner and by persons approved by the Company. Release Date: 0813
Basics Equipment Basics
Change Flavor Cartridge, if needed
1. Scan cartridge RFID tag to open door
— Hold ID tag next to scanner on door
2. Locate red LED cartridge light
3. Open cartridge slot door with the red LED light by
gently pulling down
4. Remove empty cartridge
5. Clean cartridge overflow area as needed using proper
procedures
6. Remove protective cap and paper seal from new
cartridge
7. Insert cartridge in the slot with the RFID tag facing in
8. Gently push cartridge in until the slot door is engaged
9. Close the slot door to push the cartridge in the rest of
the way. If more cartridges need to be replaced, follow
Steps 3 – 11.
— Cartridge light(s) should turn green
10.Close dispenser door(s).
11.Touch “Prime” on cartridge replacement screen
— A new screen will appear listing all secondary flavors
that require priming. Press “Prime All” until screen
reads “Done.” Then press “Return to Dashboard.”
If cartridge is
expired, RFID
tag will not
work.
A flavor is sold out or empty
when it appears with a red
X on the screen. When the
icon is touched, it will show
“Empty” on the icon.
Replace empty cartridge
with a new one of same
flavor.
Do NOT force or push the
cartridge once the slot door
is engaged.
Check Water Filter
Water filter(s) must be changed as indicated by the pressure
drop on gauge or approximately every 6 – 12 months.
 The date when the filter(s) must be changed must be
clearly visible on the filter casing. Approved filters:
— Selecto MF-620CC
— Selecto IC-10-620-2BK
— Everpure CB20-312E
— AJ Antunes GAP 20 or GAP 21
Cartridge Status Lights
The status lights in each of the cartridge slots in the
dispenser cabinet illuminate, indicating different information.
Upper and lower cabinet doors must be opened to view the
status lights.