Master Catalog

MC-DPTAC www.amana-ptac.com 3
sTandard feaTures (conT.)
• CondensateDispersionSystem: Our condensate dispersion system removes condensate from indoor cooling operation by throwing
water directly on to the outdoor coil for rapid evaporation and increased cooling efciencies. The slinger ring on the new,
enhanced fan draws water up and into the fan blades. This water is then atomized and evaporated into the atmosphere
through the condenser. Increased surface area from the coil allows more water to be evaporated on the sides of the coils and
helps to minimize condensate run-off.
• FrontDeskControl: Each unit comes equipped with the DigiSmart™ control and energy management software. With Digi-Smart™
using the optional RF antennae, all units can be wirelessly connected to a central hub for enhanced energy savings and
diagnostics. Amana brand PTACs also have a low-voltage interface capability with a eld-supplied front-desk ON/OFF switch.
(See Page 4.)
• RoomFreezeProtection: When the unit senses temperatures of 40°F or below, the unit activates the fan motor and either the
electric resistance heater or the hydronic heater.
• Easy-to-useControls: No complex controls to confuse your guests and create phone calls for your manager. Controls are easy to
read, understand, and activate. Our new 7-button control panel provided guests with complete control of the unit for their
in-room comfort while maintaining overall energy efciency.
• EasytoServicewithOn-BoardLEDDiagnostics: The main components are easily serviced and there is no guessing to determine the
problem with our easy-to-read diagnostics.
• StonewoodRoomFront: Our Stonewood room front strikes the balance between attractive styling and practical design. Distinc-
tive contours and a modern appearance enhance the character of even the most luxurious room, while the sleek 7” depth
maximizes usable space for your guests.
• RemoteThermostatControl: When the DigiSmart™ wireless remote thermostat is set up, both the remote thermostat and unit con-
trol panel continue to control the unit, providing exibility and home-like system control. Installation requires no more than
pressing two buttons. No need to run wires or make electrical connections.
• RemoteTemperatureSensing: Guests enjoy ultimate comfort with consistent climate control. When the eld-installed thermistor
(RTS03) is used, the unit-mounted thermostat is overridden to allow more accurate, internal wall-sensing of room ambient
temperature.
• ExtendedHeatPumpHeating: Heat pump models will operate in the heating mode down to as low as 24°F outdoor ambient tem-
perature.
• ZeroFloorClearance: The unit can be installed ush to a nished oor, if desired. (Some accessories do not have zero clearance).
• 30-SecondFan-OffDelay: The fan continues to run 30 seconds after the compressor has stopped in either cooling or heat pump
mode and after electric heat has been turned off. This improves efciency by dispersing the conditioned air on the coils into
the room.
• CompressorLock-In: This feature helps prolong the life of the compressor by preventing short-cycling. When the compres-sor is
switched from Off to On because room temperature has risen or fallen below the specied limit, it will remain on for at least
4 minutes. If the temperature set-point is changed during this 4 minutes, the lock-in feature is overridden.
• AutomaticEmergencyHeat: No more “my unit is not heating” complaints during the middle of the night. Heat pump units will
automatically switch over to electric resistance heat if the heat pump compressor system fails or if the heating load is greater
than the unit capacity.
• ConstantFanMode: Take advantage of each unit’s dual options — select continuous fan operation or cycle the fan ON and OFF
with the thermostat. Our new 7-button design allows guests to select fan performance while allowing the owner to have the
unit revert to the desired program of continuous fan or cycle with conditioning.
• HiddenVentilationControl: The ventilation control lever is hidden from the occupant's view to allow you to manage ventilation
requirements.
• High-PressureSwitch: Protects the unit from high pressure and damage to the unit, helping to ensure long unit life.