PTAC Accessories Catalog

10 www.amana-ptac.com CT-DPTAC
Power cord conFiguraTion
inTake air FilTers
It is extremely important to clean the inlet air lters once a month (or more oen if operated in dusty or dirty locaons or
condions) to properly maintain the operaonal performance of the PTAC unit. The two intake air lters (constructed of
durable polypropylene) can be easily inserted into the cabinet front using the cabinet lter guides. Before cleaning the intake
lters, turn the unit o by seng the mode switch to the OFF posion. Filters should be cleaned as required.The following
procedure is used to remove the intake lters:
1. Facing the unit, pull up on the lter handles located at the front top of the unit.
2. Pull each lter upward and remove.
3. Clean lters with vacuum or with running water. Reverse this procedure to reinstall the lters.
 Accessory lter kits are available from your sales person. All lters are permanent and cleanable. Consult your
I&O Manual for other monthly cleaning instrucons.
monTHly mainTenance
sPare FilTers
Helps keep dirt and lint out of the air and o the coil,
thus increasing the unit's eciency. Amana® brand
lters are easy to remove, wash and replace.
 
 
 


rePlacemenT cHarcoal FilTer kiT
Absorbs airborne odors caused by cigaree, pipe
or cigar smoke and odors caused by mold, mildew,
etc. Filters are made of polyester bers coated with
acvated charcoal and are individually wrapped.
These lters are permanent and can be washed or
cleaned. Call your Amana® brand PTAC sales person
for details. 10 lters per pack.
 
 

277V Rating Power Cord Plugs
NEMA 7 Conguration
G
W
20 amp
G
W
30 amp
250V Rating Power Cord Plugs with LCDI Device
NEMA 6 Conguration
Power Cord Plugs
15 amp
20 amp
30 amp
Power Receptacle Conguration
NEMA6-15R; 250V
receptacle used on
230/208V units
NEMA6-20R; 250V
receptacle used on
230/208V units
NEMA6-30R; 250V
receptacle used on
230/208V units
NEMA7-20R; 277V receptacle
used on 265V units
NEMA7-30R; 277V receptacle
used on 265V units
All units come with factory-installed power cords.
All units less than 250 volts come with LCDI device.