PTAC Accessories Catalog

CT-DPTAC www.amana-ptac.com 3
sTandard FeaTures (conT.)
 Our condensate dispersion system removes condensate from indoor cooling operaon
by throwing water directly on to the outdoor coil for rapid evaporaon and increased cooling eciencies. The slinger ring
on the new, enhanced fan draws water up and into the fan blades. This water is then atomized and evaporated into the
atmosphere through the condenser. Increased surface area from the coil allows more water to be evaporated on the sides
of the coils and helps to minimize condensate run-o.
 Each unit comes equipped with the DigiSmart™ control and energy management soware. Using the
DigiSmart™ soware and oponal RF Antenna, all units can be wirelessly connected to a central hub for enhanced energy
savings and diagnoscs. Amana brand PTACs also have a low-voltage interface capability with a eld-supplied front-desk
ON/OFF switch. (See Page 4.)
 When the unit senses temperatures of 40°F or below, the unit acvates the fan motor and either
the electric resistance heater or the hydronic heater.
 No complex controls to confuse your guests and create phone calls for your manager. Controls are
easy to read, understand, and acvate. Our new 7-buon control panel provides guests with complete control of the unit
for their in-room comfort while maintaining overall energy eciency.
    The main components are easily serviced and there is no guessing to
determine the problem with our easy-to-read diagnoscs.
 Our Stonewood room front strikes the balance between aracve styling and praccal design.
Disncve contours and a modern appearance enhance the character of even the most luxurious room, while the sleek 7⅝”
depth maximizes usable space for your guests.
 When the DigiSmart™ wireless remote thermostat (DS01E, sold separately) is set up, both the
remote thermostat and unit control panel connue to control the unit, providing exibility and home-like system control.
Installaon requires no more than pressing two buons. No need to run wires or make electrical connecons.
   Guests enjoy ulmate comfort with consistent climate control. When the eld-installed
thermistor (RTS03) is used, the unit-mounted thermostat is overridden to allow more accurate, internal wall-sensing of
room ambient temperature.
    Heat pump models will operate in the heang mode down to as low as 24°F outdoor
ambient temperature.
 The unit can be installed ush to a nished oor, if desired. (Some accessories do not have zero clearance).
 The fan connues to run 30 seconds aer the compressor has stopped in either cooling or heat
pump mode and aer electric heat has been turned o. This improves eciency by dispersing the condioned air on the
coils into the room.
 This feature helps prolong the life of the compressor by prevenng short-cycling. When the compressor
is switched from O to On because room temperature has risen or fallen below the specied limit, it will remain on for at
least 4 minutes. If the temperature set-point is changed during this 4 minutes, the lock-in feature is overridden.
 No more “my unit is not heang” complaints during the middle of the night. Heat pump units
will automacally switch over to electric resistance heat if the heat pump compressor system fails or if the heang load is
greater than the unit capacity.
 Take advantage of each unit’s dual opons — select connuous fan operaon or cycle the fan ON and
OFF with the thermostat. Our new 7-buon design allows guests to select fan performance while allowing the owner to
have the unit revert to the desired program of connuous fan or cycle with condioning.
   The venlaon control lever is hidden from the occupant's view to allow you to manage
venlaon requirements.
 Protects the unit from high pressure and damage to the unit, helping to ensure long unit life.