Installation Instructions

Description

Leveling legs are designed to provide extra front support

and leveling of the wall sleeve. Two leg assemblies are

required per unit and are provided in each kit. Four

screws are also provided with each kit for attachment to

the wall sleeve. See Figure 1.

The leveling legs must be installed before the chassis is

installed, but after the wall sleeve is in place. Holes must

be drilled in each side of the wall sleeve, below the duct

package holes, for attachment to the wall sleeve.

The installation and servicing of the equipment referred to

in this booklet should be done by qualified, experienced

technicians.

The installation and servicing of the equipment should be

done by qualified, experienced technicians.

PTAC

LEVELING LEGS KIT (LL2B)

NSTALLATION INSTRUCTIONS

Part No. A3495502

Printed in USA

April 2005

ADJUSTER SCREW

SPEED GRIP NUT

LEVELER BRACKET

1/2"

1/4"

NOTES:

1. Two leveling legs are supplied in each kit.

2. One kit is required per unit.

3. Four mounting screws are provided in each kit.

PAGE 1
PTAC LEVELING LEGS KIT (LL2B) INSTALLATION INSTRUCTIONS Description Leveling legs are designed to provide extra front support and leveling of the wall sleeve. Two leg assemblies are required per unit and are provided in each kit. Four screws are also provided with each kit for attachment to the wall sleeve. See Figure 1. The leveling legs must be installed before the chassis is installed, but after the wall sleeve is in place.
PAGE 2
INSTALLATION The installation and servicing of the equipment referred to in this booklet should be done by qualified, experienced technicians. To install the leveling leg assembly, complete the following: 1. Drill two 1/8-inch holes in each side of the wall sleeve, as shown in Figure 2, using the leveling leg assembly as a template. Locations near the front of the sleeve provide more support. 2.