Electric Range Technical Information

Component Testing Information
I I WARNING
To avoid risk of electrical shock, personal injury, or death, diSconnect power to oven before servicing, unless
testing requires iL
I
Illustration
053584
31715201--LH
31715202--RH
065780
305797
31797301
Component Test Procedure Results
Control limit Normally Closed
Verify proper operation.
Closed 245°F Continuity
Open 275°F Infinite
If open at roomtemperature, replace.
Hinge
Door lock switch
Door plunger switch
Autotatch assembly
withdoor plunger
switch
Carefully open the hinge fully, and
insert a wooden dowelor screwdriver
bitinto opening.
Remove top and bottom screws
: securing hinge.
Slide hinge top towards rear of unit
and guide hinge out through frame
opening or storage drawer.
Switch connectionin following
positions:
Unlooked
Looked
;et ERC to Clean
Remove switchfrom unit and measure
the following points:
C-NC
C NO
Disconnect wires and test for
continuityper diagram
I 4_ CAUTION II
Do not place hands in hinge area when
I
Ovendoor is removed. Hinge can snap
closed and pinch hands or fingers.
COM-NO=Open, COM-NC=Closed
COM-NO=Clceed, COM-NC--Open
Lock LED should flash
LookLED and Oven LED should
illuminate, If LockLED doesnot
illuminate,check switch and widng.
Plunger ininfinite, Plunger out continuity.
Plunger incontinuity, Plunger out infinite.
NC NC
__, ,_
,:....a_H.__.....___.o_ _.. ;
April 1999 3 RT2320003 Rev 9