Service manual

Disassembly
35 RS5320014 Rev. 0
WARNING
!
To avoid risk of electrical shock, personal injury, or
death, disconnect power to oven and discharge
capacitors before following any disassembly procedure.
Installation
1. Install magnetron - do not tighten nuts.
2. Install magnetron air baffle.
3. Tighten magnetron mounting nuts.
4. Reinstall middle air baffle.
5. Install bottom access cover.
6. Connect wiring to magnetron and magnetron thermal
protectors.
7. When replacing the magnetron, verify the wire mesh
gasket is reinstalled.
8. Install outer case.
Magnetron and Control Thermal Protectors
(TCO)
1. Remove outer case.
2. Remove wiring from selected thermal protector.
3. Remove 1/8" allen screw/phillips screw used to
mount thermal protectors.
Bottom Access Panel
1. Place oven on side or back.
2. Remove single bottom screw.
Bottom Stirrer Motor
1. Remove bottom access panel.
2. Remove antenna gear.
3. Disconnect brown motor wires from white and orange
chassis wires.
4. Remove two mounting rivets and remove motor.
NOTE: Do not remove bottom antenna gear when
removing motor.
Arro
w
Dot
NOTE: Gears are aligned by aligning the arrows to the
dots on gears.
Antenna
Gear
Cotter
Pin
Nylon
Washer
A
ntenna
Motor
NOTE: Nylon washers must be installed between
antenna gears and cavity.
Bottom Antenna
1. Remove shelf.
2. Set oven on side.
3. Remove bottom access panel.
4. Removal antenna gear.
NOTE: Gears are aligned by aligning the arrows to the
dots on gears.
5. Remove antenna from top.
6. Replace and reseal shelf.