Use and Care Manual

7
AIR CONDITIONER FEATURES
ELECTRONIC CONTROL OPERATING INSTRUCTIONS
Before you begin, thoroughly familiarize yourself with all of the
functions of the control panel and remote as shown below and
follow the instructions. The unit can be controlled by the touchpad
alone or with the remote control.
REMOTE
•E NSURE THERE ARE NO OBSTACLES BETWEEN THE REMOTE
CONTROL AND THE RECEIVER OF THE INDOOR UNIT .
•K
EEP THE REMOTE CONTROL AWAY FROM LIQUIDS .
•D
O NOT EXPOSE THE REMOTE CONTROL TO HIGH TEMPERATURES
OR TO RADIATION .
•K
EEP THE INDOOR RECEIVER OUT OF DIRECT SUNLIGHT .
•R
EMOTE CONTROL SHOULD BE KEPT AWAY FROM EMI
(
ELECTRO - MAGNETIC INTERFERENCE ) AS IS PRESENT IN SOME
HOUSEHOLD APPLIANCES .
NOTE: The remote control will work normally after a 5 second
reset. Use only AAA battery size.
AUTO and SAVE modes available on digital remotes only.
1. ON/OFF Button: Press this button to begin operation; press
the button again to stop operation. Turning on or off the unit
will cancel the TIMER and SLEEP functions. The pre-set time
is not altered.
2. MODE Selection Button: Each time this button is pressed, the
operation mode is shifted in the direction of the arrows shown
below:
AUTO COOL
DRY
HEAT
FA
N
AUTO mode is the default mode while the power is on. The
temperature is not displayed during AUTO mode. During HEAT
mode, the initial value is 28°C (82°F). Under the remaining
modes, the initial value is 25°C (77°F).
Centrigrade setting range is 16-30; Fahrenheit setting range
is 61-86.
AUTO - COOL - DRY - FAN - HEAT (Only for cooling and heat-
ing unit.)
3. SLEEP Button: (Conserves energy while you sleep.) When
the SLEEP button on the remote control is pressed during
Cooling, Heating (Cooling only type with no heat) or AUTO
operation, the unit will automatically increase (cooling) or
decrease (heating) 1.8°F (1°C) per hour for the first 2 hours
and will hold that temperature after 2 hours. The fan will
continue to operate.
By pressing this button, SLEEP ON and SLEEP OFF can be
selected. After turning on SLEEP mode, SLEEP OFF is the
default setting. Turning off the unit cancels the SLEEP mode
function.
After setting up the SLEEP function, SLEEP will be displayed.
During this mode, the timer settings can be changed. When
running your unit in the FAN and AUTO modes, the SLEEP
function is not available.
4. FAN Button: Used to select the fan setting in five levels of
AUTO, FAN 1, FAN 2, FAN 3 or FAN 4 and each time the button
is pressed, the fan speed mode is shifted.
NOTE: FAN 4 is available only in COOL and HEAT modes.
After turning the unit’s power ON, AUTO is the default setting.
5. + Button: When the unit is on, press this button to increase
temperature. Pressing this button for more than 2 seconds
will rapidly change the temperature setting. Discontinue press-
ing the button and the display °C (°F) will be displayed con-
tinuously.