Unit installation

Turn the unit on at the thermostat. Wait a few minutes, since

any dislodged dust will alter the normal flame appearance.

Flames should be predominantly blue and directed into the

tubes. They should not be yellow. They should extend

directly outward from the burner ports without curling down-

ward, floating or lifting off the ports.

XIII. Accessories and Functional Parts

SHEET METAL ACCESSORIES

Additional Amana accessories, as described in Table 4, can

be purchased to fit specific application needs. Accessories

can be ordered by the part numbers in the table and each

accessory includes its own separate instructions.

Accessory

Duct Transition Over/Under

Horizontal Duct Covers*

Compressor Sound Blanket

Horizontal Filter Kit

Propane Gas Conversion Kit

High Altitude Kit

* Standard on PGA**C

Table 4

Accessory List

FUNCTIONAL PARTS

Blower Housing Flame Roll-Out Switch

Blower Motor Gas Orifice

Blower Wheel Heat Exchanger

Burner High Limit Switch

Compressor Secondary Limit

Condenser Coil Ignitor/Flame Sensor

Condenser Fan Blade Induced Draft Motor

Condenser Fan Motor Pressure Switch

Contactor Pressure Switch Hose

Evaporator Coil Transformer

Fan Timer Board

Figure 18

Functional Parts List

GENERAL INFORMATION

1. Refer to the description in Figure 18 when ordering any

of the listed functional parts. Be sure to provide the unit

model, manufacturing, and serial numbers with the

order.

2. Although only functional parts are shown in Figure 18, all

sheet metal parts, doors, etc. may be ordered by de-

scription.

3. Parts are available from your Amana distributor.