PTAC Brochure/Spec Sheet

11
Specifications and Accessories Catalog
Product Specifications: PMC Models — Cooling/Electric Heat
230/208 Volts
Model 
,

,

PMC
073G***XXX
PMC
093G***XXX
PMC
123G***XXX
PMC
153G***XXX
Voltage  230 / 208 230 / 208 230 / 208 230 / 208
Capacity (BTU/h) 6,800 / 6,700 9,000 / 8,700 11,800 / 11,700 14,500 / 14,400
Amps  3.3 / 3.3 4.3 / 4.3 5.2 / 5.2 7.0 / 7.0
Watts  570 / 560 785 / 760 1,060 / 1,055 1,575 / 1,530
EER 12.0 / 12.1 11.6 / 11.4 11.0 / 11.0 9.9 / 9.9
Unit without Electric Heater
Min. Circuit Amps 
,

,
 4.9 6.2 7.3 9.6
CFM (Cool/Wet Coil)
High 290 290 290 340
Low 264 264 264 314
CFM (Dry Coil)
High 310 310 310 360
Low 282 282 282 332
Ventilated Air, CFM (Fan Only)* 65* 65* 65* 65*
Dehumidification (Pints/Hr.) 1.7 2.2 3.6 4.4
Net Weight (lbs.) 118 122 122 133
Ship Weight (lbs.) 133 137 137 148
* Actual vent CFM performance will vary due to application and installation conditions.
N
 All 265-volt models must use an Amana® brand sub-base (PTSB4**E) or an Amana® brand hard-wire kit PTPWHWK4 and disconnect switch PSHW04A.
 Minimum Circuit Ampacity (MCA) ratings conform to the National Electric Code; however, local codes should apply.
 Minimum voltage on 230/208-volt models is 197 volts; maximum is 253 volts. Minimum voltage on 265-volt models is 239 volts; maximum is 292 volts.
 Overcurrent protection for all units without electric heaters is 15 amps. Overcurrent protection on 265-volt models must be cartridge-style time-delay
fuses (included and factory-installed on all Amana® brand 265-volt chassis). See heater performance
 Heating capacity and eiciency based on unit operation without condensate pump.
 Specify two-digit heater kW size to complete model number.
 R-410A refrigerant used in all systems.
 All units meet or exceed ASHRAE 90.1 standards.
 All units less than 250 volts have a Leak Current Detector Interrupter (LCDI) power cord and meet UL 484 standards.
 Refer to electric heat performance data for total MCA and recommended overcurrent protection. Amps and Watts notation refers to compressor only.