PTAC Grille Installation Instructions

PTAC
S TANDARD L OUVERED O UTDOOR G RILLE
INSTALLATION INSTRUCTIONS
IO-802
3/2013
Standard Louvered Grille
NOTE: A baffle kit must not be used with a standard louvered
grille on any PTAC installation.
NOTE: Remove rear baffles attached to the condenser coil
header plate in the unit if installed with stamped aluminum grille.
Before installing the grille, remove the cardboard stiffener and
rear enclosure panel from the wall sleeve. These items can be
removed from inside of the building. The sleeve stiffener must
be taken out before the rear sleeve enclosure panel can be
removed from the sleeve.
Rear Enclosure Removal
Remove the rear enclosure by folding the front ends of the top
and bottom towards the center. Grasp the top and bottom
flanges as shown in Figure 2 and pull out diagonally from one
side of the sleeve.
Standard Louvered Grille Installation Instructions
Figure 1
1. Position the grille so that all four flanges are in the up
position.
2. Insert the six grommets provided so the square end pro-
trudes through the grille in the opposite direction from the
flanges.
3. Manipulate the grille out through the rear sleeve opening
using the plastic handle (not shown) provided.
4. Secure the grille by threading each of the six screws into
the plastic grommets.
5. Remove the plastic handle (not shown) from the center of
the grille prior to installing the chassis into the sleeve.
The installation and servicing of this equipment should be performed
by qualified, experienced technicians.