Manualshelf

R-410A PTAC/PTHP Spec Sheet

ManualsBrandsAmana ManualsHeating, Ventilation, and Air Conditioning15,000 BTU R-410A Packaged Terminal Air Conditioning + 3.5kW Electric Heat 230V
12345678
SS-DPTAC www.amana-ptac.com 5
4 www.amana-ptac.com SS-DPTAC
P
roduCT
s
PeCifiCATions
P
roduCT
s
PeCifiCATions
(Primary Heating for PTC Models; Auxiliary Heating for PTH Models; See below for Power Cord Conguration)
ProduCT sPeCifiCATions: PTC / PTH models — eleCTriC HeAT PerformAnCe
Voltage
Electric
Heat (kW)
No. of
Stages
Nominal Heating (BTU/h)
Total
Watts
6
Total
Amps
Min. Circuit
Ampacity²
MOP
4
(amps)
Power
Cord
@ 230V @ 208V @ 265V
230/208V 2.5 1 8,500 6,800 - - 2,570 / 2,115 11.2 / 10.1 14.0 15 6-15 P
230/208V 3.5 1 12,000 9,900 - - 3,570 / 2,935 15.5 / 14.1 19.4 20 6-20 P
230/208V 5 1 17,100 14,000 - - 5,070 / 4,160 22.1 / 20.0 27.5 30 6-30 P
265V 2.5 1 - - - - 8,500 2,570 9.7 12.1 15 7-20 P
265V 3.7 1 - - - - 12,600 3,770 14.2 17.8 20 7-20 P
265V 5 1 - - - - 17,100 5,070 19.2 23.9 25 7-30 P
Notes
¹ All 265-volt models must use an Amana® brand sub-base (PTSB4**E) or an Amana® brand hard-wire kit PTPWHWK4 and disconnect switch PSHW04A.
² Minimum Circuit Ampacity (MCA) rangs conform to the Naonal Electric Code; however, local codes should apply.
³ Minimum voltage on 230/208-volt models is 197 volts; maximum is 253 volts. Minimum voltage on 265-volt models is 239 volts; maximum is 292 volts.
⁴ Overcurrent protecon for all units without electric heaters is 15 amps. Overcurrent protecon on 265-volt models must be cartridge-style me-delay
fuses (included and factory-installed on all Amana® brand 265-volt chassis). See heater performance
⁵ Heang capacity and eciency based on unit operaon without condensate pump; unit automacally switches to electric heat at approximately 24°F
outdoor ambient.
⁶ Specify two-digit heater kW size to complete model number.
⁷ R-410A refrigerant used in all systems.
⁸ All units meet or exceed ASHRAE 90.1 standards.
⁹ All units less than 250 volts have a Leak Current Detector Interrupter (LCDI) power cord and meet UL 484 standards.
¹⁰ Refer to electric heat performance data for total MCA and recommended overcurrent protecon. Amps and Was notaon refers to compressor only.