Owner`s manual

14
Before Calling for Service
If oven does not operate:
Confirm oven is plugged into dedicated circuit.
Confirm oven is on earthed and polarized circuit.
(Contact electrician to confirm)
Check fuse or circuit breaker.
If oven light does not work:
Confirm light bulb is screwed in tightly.
Confirm light bulb is not defective.
If oven operates intermittently:
Check filter inlet and discharge areas for
obstructions.
If oven does not accept entries when pad is pressed:
Open and close oven door. Press pad again.
If oven malfunctions:
Unplug oven, wait for 1 minute, and plug in oven.
If oven operates, but will not heat food:
Place one cup cool water in oven. Heat for one
minute. If water temperature does not rise, oven
is operating incorrectly.
Warning
To avoid electrical shock which can cause severe
personal injury or death, do not remove outer case
at any time. Only authorized servicer should
remove outer case.
Service Codes
During operation, display may show service codes:
S1
CS
PCE1
PCE5
PCE6
FL
FH
PL
-HOT
HI
LO
Contact an authorized servicer if display shows any
code except “HOT”, “HI”, and “LO”. Service must be
performed before using oven.
If display shows “HOT”, oven's magnetron tube is
overheated. Oven automatically interrupts
cooking sequence and turns on cooling fan until
magnetron tube reaches normal temperature.
When magnetron tube cools to normal
temperature, oven resumes normal operation.
If display shows “HI” or “LO”, input voltage is too
high or too low . Because cooking results vary
from the normal cooking pattern, oven is not
usable during this condition. Normal operation
returns once voltage returns to normal range.
When contacting supplier, provide product information
including model, serial, and manufacturing numbers,
and date of purchase. Model, serial, and manufacturing
numbers are located on product serial plate. Warranty
service must be performed by authorized servicer.
Amana also recommends contacting authorized
servicer if service is required after warranty expires.