Operation Manual

3
Proper Disposal of your
Refrigerator
IMPORTANT: Child entrapment and suffocation are not
problems of the past. Junked or abandoned refrigerators
are still dangerous—even if they will sit for “just a few
days.” If you are getting rid of your old refrigerator, please
follow the instructions below to help prevent accidents.
BEFORE YOU THROW AWAY YOUR OLD
REFRIGERATOR OR FREEZER:
• Take off the doors.
• Leave the shelves in place so that children may
not easily climb inside.
Installation Instructions
A qualified engineer must connect refrigerator in
accordance with these installation instructions.
Measure door opening and depth and width of refrigerator.
Remove handles or doors if required. Engineer must also
do the following:
1. Follow local water and electrical company connection
regulations.
2. Complete water supply connection before electrical
supply connection.
Service to or replacement of power cord must be
performed by a qualified servicer.
Installation Requirements
1. Install on an earthed outlet with a separate 230 volt,
50hz., 10A circuit.
2. Protect soft flooring with cardboard or rugs.
3. Install on a floor which supports up to 429 kg.
4. Provide 5 mm clearance at side of refrigerator and for
models more than 60 cm deep, provide 25 mm
clearance at top of refrigerator.
5. 60 cm deep models.
Trim corners of counter top to a 45° angle if counter
top has 25 mm overhang.
Removing Wooden Base
CAUTION
To avoid personal injury or property damage, two
people must remove wooden base.
1. Tape doors shut to prevent doors from opening
unexpectedly.
2. Slide appliance cart under side of refrigerator.
3. Wrap refrigerator with blanket or pad. Thread strap
around refrigerator. Put foam shipping pads, located in
shipping carton, under strap. Tighten strap securely.
4. Lower appliance cart to floor with appliance cart
handles on bottom.
5. Remove top two bolts from skid.
6. Return refrigerator and appliance cart to an upright
position. Remove strap.
7. Slide appliance cart under opposite side of
refrigerator.
8. Repeat steps 3–5.
9. Remove wooden base.
10. Return refrigerator and appliance cart to an upright
position and remove appliance cart.
IMPORTANT:
Do not leave refrigerator on its side longer than necessary
to remove bolts.